Cabletron Systems SmartSwitch - Manual (Page 37)

SmartSwitch Router User Reference Manual 37
Chapter 1: SSR Product Overview
Configure Mode
Configure mode provides the capabilities to configure all features and functions on the
SSR. You can configure features and functions within Configure mode including router
configuration, access control lists and spanning tree.
To list the Configure commands, enter:
The Configure mode command prompt consists of the SSR name followed by the pound
sign (#):
To list the commands available in Configure mode, enter a question mark (?) as shown in
the following example:
List the Configure commands. ?
ssr(config)#
ssr(config)# ?
acl
- Configure L3 Access Control List
acl-edit - Edit an ACL in the ACL Editor
acl-policy - Configure ACL policy
aging - Configure L2 and L3 Aging
arp - Configure ARP entries
bgp - Configure Border Gateway Protocol (BGP)
cli - Modify the command line interface behavior
dhcp - Configure DHCP server
dvmrp - Configure DVMRP related parameters
exit - Exit current mode
filters - Configure L2 security filters
frame-relay - Configure wan interface parameters
help - Describe online help facility
igmp - Configure IGMP related parameters
interface - Configure interface related parameters
ip - Configure IP related parameters
ip-policy - Configure IP policy for packet forwarding
ip-redundancy - Configure IP redundancy protocols
ip-router - Configure Unicast Routing Protocol related
parameters
ipx - Configure IPX related parameters
lfap - Configure Lightweight Flow Accounting Protocol
client
load-balance
- Configure Load Balancing related parameters
nat - configure network address translation
parameters
ntp
- Configure Network Time Protocol (NTP)
parameters
ospf
- Configure Open Shortest Path Protocol (OSPF)
port - Configure Port parameters
ppp - Configure wan interface parameters