TYREDOG TD-2300A-X10 - Manual (Page 46)

TD-2300A Series V1.0 44
TroubleShooting Continued..
5) Wheel Layout keeps defaulting back to the old Wheel Layout
What can I do?
If you ever change the Wheel Layout configuration in the Type of vehicle
menu, you must reset /save these new layouts to the Relay/s. Refer Page
#31.
6) I can’t Program / Add a new Sensor
What can I do?
To program new Sensors, they must be a LEARNABLE TD-SN-2300A-X
type Sensor only. Please refer to Pages #33 - #35 and make sure the full
procedure was followed.
7) I can’t Program / Add a new Relay
What can I do?
To program new Relay/s, they must be a TD-RLY-2300A type Relay only.
Make sure Relay/s have power and Batteries are not flat.
Please refer to Pages #31 - #32 and make sure the full procedure was
followed.
8) What happens if I lose or damage a Sensor
What can I do?
If a Sensor is lost or Damaged you can order a replacement LEARNABLE
sensor. Please refer to page #33 for further information.