TYREDOG TD-2300A-X10 - Manual (Page 45)

TD-2300A Series V1.0 43
TroubleShooting Continued..
3) Sensor is Online but is not Reading Pressure
What can I do?
Firstly make sure the Sensor is screwed on properly. If it’s not screwed on
enough to open the valve then it cannot read pressure.
You can then try fitting the sensor to another Tyre to see whether it’s a
Sensor problem or Valve problem.
If the sensor still doesn’t read pressure on another Tyre, please try a new
Battery (CR1632 3V). If you don’t have a new battery simply remove a
Battery from a known working Sensor and try this.
If you tried the Sensor on another Tyre and it read pressure ok, then it’s
possible that the Sensor can’t release the valve on that particular Tyre.
A Tyre fitter / Repair shop should be able to resolve this issue.
4) Erratic / Inaccurate Pressure Readings.
What can I do?
Firstly make sure the Sensor is screwed on properly. If it’s not screwed on
enough, this will cause Erratic pressure readings.
If the sensor still causes Erratic readings, please try a new Battery
(CR1632 3V). If you don’t have a new battery simply remove a Battery
from a known working Sensor and try this.
You can also check Relay Connection Status and Power. (Especially if
you’re using AA Batteries to power the Relay)
If none of these recommendations fix the problem then please contact
your authorised Tyredog dealer.