TYREDOG TD-2300A-X10 - Manual (Page 19)

TD-2300A Series V1.0 17
Installation - Monitor / Receiver Bracket
4. Place the Monitor Bracket into the Bracket Adaptor clips.
5. Gently push the Monitor Bracket against the adaptor clips and slide
down until the Monitor Bracket locks in place.
6. Now connect the Monitor Bracket to the Monitor and screw it into place.
7. Position the Bracket Suction Cup to a suitable location on the
windscreen ensuring it doesn’t obstruct the view of the driver.
8. Once in position, push down on the base and lower the Suction Cup
Lock to apply suction.
9. You can then adjust the monitor angle and tighten the Ball Joint Ring.