Figure 7 – Tuffy Security 157 User Manual
Page 8
Page 8 of 10 - 01/23/2012 – Rev05192008
35.
If the vehicle is not equipped with the electric rear window switches (#6.3 – Fig 7) then install the Switch Hole Plate (#18 – Fig
7).
36.
If the vehicle is equipped with the electric rear window switches (#6.3 – Fig 7) install them in the Tuffy console using the
provided Switch Cover (#10 – Fig 7). Make sure the tabs on the top and bottom of the switches are inserted in the corresponding
slots in the Switch cover and console.
37.
If the vehicle is equipped with the electric rear window mounting switches (#6.3 – Fig 7) plug the original factory harness into the
switches which were previously mounted in the console. Then support the wiring harness by attaching the Mounting Head zip
ties (#6.8 – Fig 7) to the wiring harness then fastening them to the holes in the Tuffy console.
38.
Install the rear drink holder (#9 – Fig 7).
FIGURE 7
- 082 (2 pages)
- 089 Manual (3 pages)
- 089 Installation Manual (1 page)
- 101 (2 pages)
- 073 (3 pages)
- 198 (2 pages)
- 189 (1 page)
- 292 (2 pages)
- 282-BTL (1 page)
- 137 (2 pages)
- 295 (3 pages)
- 862 (2 pages)
- 863 (3 pages)
- 311 (2 pages)
- 312 (2 pages)
- 046 (3 pages)
- 145 (4 pages)
- 131 (2 pages)
- 297 (3 pages)
- 296 (3 pages)
- 240 (10 pages)
- 238 (2 pages)
- 058 (3 pages)
- 219 (2 pages)
- 195 (2 pages)
- 144 (2 pages)
- 274 (10 pages)
- 139 (3 pages)
- 052 (2 pages)
- 164 (1 page)
- 104 (1 page)
- 043 (1 page)
- 027 (2 pages)
- 035 (2 pages)
- 108 (2 pages)
- 149 (2 pages)
- 049 (2 pages)
- 036 (2 pages)
- 160 (3 pages)
- 289 (2 pages)
- 287 (3 pages)
- 283 (3 pages)
- 309 (2 pages)
- 182 (2 pages)