Tuffy Security 157 - Manual (Page 5)

Page 5 of 10 - 01/23/2012 – Rev05192008
If you are installing a Stereo, CB, or other electronic equipment in the console:
25.
Run all the required stereo and speaker wires to the console mounting location. Tuffy recommends running wires in a protective
wire loom and using rubber grommets when passing through any drilled holes. ATTENTION: Refer to your electronics
owner’s manual for instructions on how to mount and wire your electronics.
Stereo mounting note: If a stereo is to be mounted in the console an antenna extension wire will be required and is available at most
stereo equipment stores.
CB mounting note: Tuffy recommends mounting an external CB speaker. These are available at most electronics supply stores.
26.
Install the rubber seal around the inside perimeter of the lid on the flat surface. (Fig 3)
FIGURE 3
27. Check the lock and latch operation on the Tuffy console.
28.
The #19 Bottom mounting plate is fastened to the console at the factory to prevent shipping damage. This plate must be removed
for installation then it will be refastened later. (See Figure 8)
29.
If you have a manual transmission the automatic transmission bracket (#14 – Fig 4) will need to be un-fastened and removed from
the Tuffy console and the Manual transmission bracket (#13 – Fig 4) will need to be installed in its place.
FIGURE 4