Compass view/return to point, Circle pivot guidance – TeeJet CenterLine 230BP User Manual
Page 21

Chapter 3 - Operation
20
5. Drive to the desired location of Point A. With the vehi-
cle in motion, press the Mark A-B key to establish
Point A. Point B will be displayed on the screen. Drive
to the location of Point B and press the Mark A-B
key again to establish the A-B line. Point B must be
at least 1/2 of the way around the circle to complete
the circle pivot. Once Point B has been established,
the CenterLine 230BP will begin providing navigation
information with the lightbar and Navigation Screens.
6. Use the Change Page key to advance the screen
views.
Compass View/return to point
Press the Return to Point key to es-
tablish a point in memory. Normal guid-
ance will continue uninterrupted during
this process.
To navigate back to the established
point, press the Return to Point key
again. The Compass View screen will
be displayed and will provide navigation
assistance to return to the established
point.
Push the Return to Point key a third
time to erase the stored point and return
to the navigation screens.
6. Use the Change Page key to advance the screen
views.
Circle pivot Guidance
Circle Pivot guidance provides guidance around a central
location that radiates outward.
NOTE:
Steps 1 - 3 are not applicable if a SmartCa-
ble or SDM is not installed on the system.
1. Turn the controller master switch to the “On” position.
The individual boom section switches should remain
in the “Off” position.
2. To activate automatic boom section control, press the
Swath Status Switch key until Auto Mode is illumi-
nated on the console.
3. In areas where application is not desired, manually
turn “Off” the rate controller master switch to shut off
the booms. Turn the master switch “On” to resume
application.
4. Use the Guidance Mode key to select Circle Pivot
guidance.
a
B
6.0 MPH
aLL on
auto
Man
Establish
Point A
+0
+0
Establish
Point B
+0
0.0
Navigation
Screen
+0
Establish
Point A
Establish
Point B
+0
+0
0.0
Navigation
Screen