Tilt gyro setup mode – TeeJet CenterLine 230BP User Manual

Page 13

Chapter 2 - Setup

ValVe TesT

Valve Test is used to verify if the steering is directed cor-

rectly and to determine the amount of time required to

move the steering wheels from fully left to fully right. Use

the Plus or Minus keys to adjust the left, right, and

off values. The Plus key turns to the right, the Minus

key turns to the left, and pressing either one again will stop

the turn. Press the Enter key to accept the changes and

advance to the Display Setup Mode.

Once the final setting has been entered and saved, the

screen will return to the initial CL230BP Assisted Steering

Screen. If no additional changes are required, press the

Escape key to exit to Operation Mode.

WARNING: PINCH POINT HAZARD! To pre-

vent serious injury or death, avoid unsafe

practice while manually operating hydraulic

steering circuits. keep others away and stay

clear of mechanical steering linkages.

Tilt Gyro setup mode

NOTE:

If a Steering Control Module (SCM) or a

Tilt Gyro Module are not connected to the

system, Tilt Compensation Setup Mode

will not be displayed. Proceed to the next

section.

NOTE:

If a Tilt Gyro Module is connected but

an SCM is not, the following screen will

be displayed instead of the standard Tilt

Gyro screens. The screen will display the

software version.

Tilt corrected GPS positions provide

improved guidance performance in hilly

terrain. To provide accurate tilt correc-

tion, the operator must calibrate the

Steering Control Module (SCM). The

CL230BP will detect if an SCM is con-

nected. If connected, tilt calibration can

be performed.

Press the Setup Mode key until the initial Tilt Calibra-

tion Setup Mode screen is displayed.

Press the Enter key to save the set-

ting and advance the screen. Press the

Escape

key to exit from Setup Mode

without saving any changes. After 10

seconds of inactivity, Setup Screens will

time out (changes will be saved). The

CL230BP will return to Operation Mode.

TIlT GYro

The Tilt Gyro Module allows for tilt cor-

rection. A Tilt Correction On/Off page

will be displayed. If the page displays

an empty checkbox, the Tilt Calibration

screens will not be available. If the box is

checked, the Tilt Calibration screens will

be accessed. If the box is checked and a

calibration has already been performed,

press the Escape key to avoid per-

forming an additional calibration proce-

dure.