TeeJet CenterLine 230BP - Manual (Page 14)

CenterLine 230BP
98-05112 R4
13
fInal TIlT CalIbraTIon sCreen
The Final Tilt Calibration Screen will be
displayed. This will show that Tilt Calibra-
tion has been completed. After 5 seconds
the screen will time out and return to the
Operation screen.
display setup mode
Press the Setup Mode key until the initial Display Setup
Mode screen appears.
dIsplaY seTup sCreen
This is the initial Display Setup Screen.
Setup screens will time out after 10 sec-
onds of inactivity (changes will be saved).
After time out, the screen will go back to
Operation Mode. Pressing the Escape
key will also exit the user from Set-
up Mode without saving any changes.
Press the Enter key to advance to the
Display Brightness setting.
dIsplaY brIGhTness
The Plus and Minus keys can be
used to change the brightness levels of
the display screen. Press the keys until
the desired brightness is established.
Press the Enter key to advance to the
Display Contrast setting.
Check/Uncheck the box by using the
Plus or Minus keys. The Plus
key selects (checks) the box. The Minus
key deselects (unchecks) the box.
Press the Enter key to accept the
changes and advance to the Antenna
Height setting.
anTenna heIGhT
Measure the height of the antenna from
the ground. Enter the antenna height (in
feet and tenths of feet) (meters) on the
antenna height page using the Plus
and Minus keys. Press the Enter
key to accept the changes and advance
to the Level One setting.
leVel one
Position the vehicle on a level surface.
Press the Enter key to advance to the
next Level screen.
leVel TWo
Turn the vehicle 180 degrees and repo-
sition the vehicle at the same location.
Press the Enter key to record the
level position.
4
5
12.5
2
3