TeeJet IC18 NH3 JOB COMPUTER - Manual (Page 48)

42
www.teejet.com
ISOBUS Job Computer : IC18 NH3
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
Section and Icon Descriptions
Section or Icon Description
Job Information This information bar displays the active count
number, applied volume and applied area
C n t 1 0 g a l 0 . 0 0 a c
Count Number Displays the current active trip or job number
Applied Volume Displays volume applied for the selected count number
Applied Area Displays applied area for the selected count number
Speed/Application
Information
Displays vehicle speed or volume applied per minute or projected area per hour to
be covered or projected total area remaining to be covered depending upon which
view is active.
The Information Key toggles between display modes.
Remaining Tank
Contents
Displays the remaining tank content
NOTE: If the contents are not entered in the Tank Filling Menu prior to
applying, Tank Contents may not display the correct amount.
Application Rate Displays the actual application rate per hectare/acre
Alarm Displayed if an alarm condition is active
Boom Sections Displays the active and inactive
boom sections as well as if they are on
(spray is blue) or off (spray is gray).
NH3 Mode Active
NH3
Displays if the unit is in NH3 mode.
Pressure Range This information section displays the target pressure and the current working
pressure.
Target Rate Displays the current targe rate
Target Rate
Percentage
Increase/
Decrease
Displays boost percentage step, i.e. the step size, at which the
application rate is to increase/decrease with the boost function
Current Pressure
Rate
Displays the current pressure to the nozzle
ECU ID Number Displays the soft key number assigned to the displayed IC18 ECU.