TeeJet IC18 NH3 JOB COMPUTER - Manual (Page 42)

36
www.teejet.com
ISOBUS Job Computer : IC18 NH3
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
Diagnostic
Figure 3-30: Diagnostic
Figure 3-31: Test Input
Diagnostic is used to troubleshoot input/output of the
controller (sensor or actuator).
►Test Input – displays the input high and low values on
the installed sensors.
►Test Output – sets the Liquid Valve PWM Dutycycle
percentage as well as if Liquid Valve Direction, Master
Valve, Fill Valve and Section Valves 1-9 are on or off.
►VT – provides information regarding the virtual terminal
controller.
►TECU – provides information regarding the TECU.
Test Input
Test Input displays the input high and low values on the
installed sensors.
• To reset the sensors to "0",
select TRASH CAN KEY .