TeeJet IC18 NH3 JOB COMPUTER - Manual (Page 17)

11
98-05230 R0 US
ISOBUS Job Computer : IC18 NH3
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
Main Setup Mode
The main setup menu contains six options. Each of these options either directly access settings or
additional menus.
Figure 2-7: Main Setup Screen
Home Key
Back One Screen
Up One Selection
Down One Selection
Master Screen Key
Forward One Screen
The table below outlines the additional menus and directs you to the setup pages for further information.
MAIN SETUP MODE MENU STRUCTURE
| | | | | |
Counters
(pages 18-21)
Job Parameters
(pages 22)
Machine
(pages 23-31)
User Interface
(pages 32-33)
Communication
(pages 34)
Help
(pages 35-38)
Trip Filling Diagnostic
Campaign Operation About
Total Implement parameters – Section width
Export Counters Implement
speed sensor
–
Calibrations Regulation parameters
Flow sensor Alarm configurations
OEM
– Sensor presence
Implement parameters
Valve setup
Tank setup
Regulation details
Clear total counters
NOTE: Select functions may not be visible due to OEM settings,
available equipment or sensors.
The OEM setup menu is password protected and the settings
in this menu are directly related to the fitted OEM equipment.
Refer to the IC18 Sprayer/NH3 OEM Setup Manual for
information regarding OEM settings.