TeeJet IC18 NH3 JOB COMPUTER - Manual (Page 32)

26
www.teejet.com
ISOBUS Job Computer : IC18 NH3
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
Implement Parameters
Figure 3-17: Implement parameters
Figure 3-18: Section Width
Figure 3-19: Regulation Parameters
Implement Parameters establishes the following:
►Section Width – sets the spraying width during
application.
►Regulation Parameters – establishes adjustments to
the rough and fine valve calibrations.
Section Width
Section Width sets the spraying width during application.
Boom Section Width
Section Width establishes the boom sections widths for
each boom section.
NOTE: The number of boom sections available is set on
the Implement Parameters screen in the OEM
section.
• To select the Boom Section Width, use the number
pad or slide bar.
One-Touch Equal Widths
One-Touch Equal Widths sets all boom section widths to
the value set for #1 Boom Section.
• To set all boom section widths, press the EQUAL
SECTION WIDTH KEY .
Regulation Parameters
Regulation Parameters establishes adjustments to the
valve calibrations.
NOTE: Adjusting the Valve Calibration settings involves
significant changes and adjustments should
therefore be made in small steps.
Valve Calibration, Rough
Rough regulation value calibration allows you to
regulate the speed of the pressure regulating valve to
accommodate different application needs. Operating
conditions may necessitate a higher or lower response