TeeJet IC18 SPRAYER JOB COMPUTER - Manual (Page 20)

15
98-05204 R1 UK
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
ISOBUS Job Computer : IC18 Sprayer
Density Factor
Density Factor establishes the weight per volume setting based on the type of fertilizer being used.
• To select the Density Factor, use the number pad or slide bar.
The fertilizer’s ability to flow is affected by a number of factors. These factors may vary with each batch and it may change due to weather
(humidity, etc.). In order to accommodate for this, the job computer uses a density factor to compensate for the nature of the applied
fertilizer.
Full Tank
Full Tank returns the Actual Content volume value to the maximum volume of the tank
• To reset the Actual Content value, press the FULL TANK KEY .
Operation
Figure 3-14: Operation
Figure 3-15: Step % Increase/Decrease
C n t 5
5 . 0 2 8 3
4 0 7 0 l
2 8
b a r
1 . 1 4 h a
+ 5 %
1 3 11 l / h a k m / h
Operation establishes Application Rate Step, Speed Source and Simulated Speed.
Application Rate Step
Application Rate Step is the percent of increase/decrease “boost” of the active
application rate at which the product is being applied.
• To select the percentage, use the number pad or slide bar.
Speed Source
Speed Source selects whether to base the machine’s speed on input from the
CAN, an Implement or a Simulated source. Selecting “Implement” will allow for
the configuration of pulses per 100 meters. Selecting “Simulated” will allow for
simulated speed to be entered using the “Edit Value” option. Selecting “CAN”
allows for speed being supplied by the ISOBUS CAN (usually from the TECU) to be
used.
• To select the Speed Source, select an option from the drop down menu or use
the UP/DOWN ARROWS to highlight the option.
NOTE: If “Implement” is selected, refer to the Calibrations section for further
instructions.
Simulated Speed
Simulated Speed establishes a speed to be used when using the Simulated Speed
source.
• To select the Simulated Speed, use the number pad or slide bar.