TeeJet IC18 SPRAYER JOB COMPUTER - Manual (Page 19)

14
www.teejet.com
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
ISOBUS Job Computer : IC18 Sprayer
MACHINE
Machine configures machine settings. Options include Filling, Operation, Implement Parameters, Calibrations,
Alarm Configurations and OEM.
MAIN SETUP MODE MENU STRUCTURE
| | | | | |
Counters Job Parameters Machine User Interface Communication Help
Filling
Operation
Implement parameters – Section width
Implement speed sensor – Calibrations Nozzle preset setup
Flow sensor Alarm configurations Regulation parameters
OEM
The OEM setup menu is password protected and the settings in this menu are directly related to the fitted OEM equipment.
Figure 3-12: Machine
1. From the Main Setup Screen , select MACHINE.
2. Select from:
►Filling – establishes the amount of material remaining in the tank and the
density of that material.
►Operation – establishes Application Rate Step, Speed Source, and
Simulated Speed.
►Implement Parameters – establishes the Section Width, Nozzle Preset
Setup and Regulation Parameters.
►Calibrations – establishes either manual or automatic settings of the
sensors.
►Alarm Configurations – establishes alarms for CAN Speed Source Timeout,
Active Trip Count Information mode and Tank Content Minimum
►OEM – The OEM setup menu is password protected and the settings in this
menu are directly related to the fitted OEM equipment. Refer to the OEM Manual for information regarding OEM settings.
NOTE: Settings are NOT automatically saved when selected. The ACCEPT KEY must be selected to save the setting. Select the
ESCAPE KEY to escape without saving settings and return to the previous menu.
Filling
Figure 3-13: Filling
Filling establishes the amount of material remaining in the tank and the density of
that material.
Different options will be available depending on if a tank sensor is installed.
NOTE: The size of the tank is established in the OEM menu. This is the number
that will repopulate when the Full Tank Key is pressed.
Actual Content
Actual Content displays the current volume of content in the tank. The volume can
be manually adjusted.
• To adjust the volume, use the number pad or slide bar.
NOTE: When a tank sensor is active, the actual content can not be changed
manually.
Density
Density establishes the density of the material being applied. It can be set to either
“fertilizer” or “water”.
• To select the Density, select an option from the drop down menu or use the
UP/DOWN ARROWS to highlight the option.
NOTE: If “Fertilizer” is selected, a Density Factor option appears.