Caution – SUUNTO VYTEC User Manual

Page 65

CAUTION!

Defects caused by improper battery installation are not covered by

the warranty.

BATTERY KIT

The transmitter battery kit includes a 3.0 V CR ½ AA lithium cell battery

and a lubricated O-ring. When handling the battery do not make con-

tact with both of the poles at the same time. Do not touch the metal

surfaces of the battery with your bare fingers.
TOOLS REQUIRED

A Phillips head screwdriver

Soft cloth for cleaning.

TRANSMITTER BATTERY REPLACEMENT
To change the transmitter battery, follow the procedure below:
1. Remove the transmitter from the regulator HP port
2. Unscrew and remove the four Phillips screws on the back of the

transmitter

3. Pull off the transmitter cover
4. Carefully remove the o-ring. Be careful not to damage the sealing

surfaces.

5. Carefully remove the battery. Do not touch the electrical contacts

or the circuit board

Check for any traces of flooding, or for any other damage. In case of a

leak or any other damage, bring the transmitter to an authorized SUUN-

TO dealer or distributor for check and repair.
6. Check the condition of the O-ring; a defective O-ring may indicate

sealing or other problems. Dispose the old O-ring, even if it seems

to be in good condition.

7. Check that the o-ring groove and the sealing surface of the cover

the are clean. Clean with soft cloth if necessary.

8. Gently insert the new battery in the battery compartment. Check

the polarity of the battery: the + mark should point toward the top

of the compartment and the - mark towards the bottom.