Water contacts – SUUNTO VYTEC User Manual

Page 14

Press the SMART (MODE) button

To activate the dive computer.

To change from the Surface Mode to the menu based modes.

To select, confirm or quit a submode (short press).

To immediately exit any submode to the Surface Mode

(long press).

To activate the electroluminescent backlight (in the Surface

Mode hold down the mode button for more than two (2)

seconds, during a dive for one (1) second).

To activate the gas change mode during a dive hold down the

mode button for more than two (2) seconds.

Press the arrow up scroll (PLAN) button

To activate the timekeeping display, if the display is blank.

To activate the Dive Planning in the Surface Mode.

To make a special bookmark in the profile memory during a dive.

To scroll up the options (

, increase).

Press the arrow down scroll (ALTER) button

To activate the timekeeping display, if the display is blank.

To activate the alternative display(s).

To scroll down the options (

, decrease).

The dive computer is controlled with the SMART (MODE/On/Backlight/

/Select/OK/Quit) and the

PLAN and TIME

push buttons and with

the water contacts as follows:

Activation

press the SMART (On) button or immerse the

instrument in water for five (5) seconds.

Dive Planning

in the Surface Mode, press the PLAN (s) button.

Menu Modes

press the SMART (MODE) -button.

The display is illuminated in surface mode by holding down the SMART

button for more than two seconds .

2.3. WATER CONTACTS

The water contacts control the automatic activation of the Dive Mode.
The water and data transfer contacts are located on bottom of the case

(Fig 2.3). When submerged the water contacts are connected to the

push buttons (which are the other pole of the water contact) by the

conductivity of the water. The AC text (Active Contacts, Fig. 2.4.) will

appear on display. The AC text will be shown until the water contact

deactivates or the dive computer enters the Dive Mode automatically.