SUUNTO VYTEC - Manual (Page 53)

51
al warnings. Cylinder pressure drop is simu-
lated with a constant, depth dependent con-
sumption. If multiple gas mixes are set they
will be changed as soon as allowed maximum
depth is reached upon ascent and in the or-
der of: MIX1, MIX2 and MIX3
To enter the Dive Simulator mode select
MODE- 2 SIMUL- 1 SIMDIVE (Fig. 4.17. and
4.18.).
4.2.2. Dive Planning Simulator
[2 SIMPLAN]
The Dive Planning Simulator mode shows
you the present no-decompression limits. In
this mode, you are also able to add the de-
sired surface interval increment to present
surface interval time, which allows you to plan
your dives in advance.
This mode is also used to add the desired
surface intervals for dive simulations. Add the
desired surface interval increment to present
surface interval by pressing the arrow down
(TIME) and arrow up (PLAN) buttons.
NOTE! This display is only shown for repeti-
tive dives.
To enter the Dive Planning Simulator mode
select MODE- 2 SIMUL- 2 SIMPLAN (Fig.
4.19.).
NOTE! The Dive Planning Simulator mode is
disabled in Gauge mode and in Error mode
(see section 3.9. ”Error Conditions”).
4.3. SET MODES [3 SET]
The Set Modes (Fig. 4.22.) are divided into
three submodes for setting the dive-related
parameters, time-related parameters and
your personal preferences.
Fig. 4.20. Selected Dive
Planning Simulator
mode. Add desired
surface interval
increment (to present
shown surface interval)
by pressing TIME and
PLAN buttons. This
display is only shown
for repetitive dives.
Fig. 4.21. Dive
Planning Simulation.
TIME
SURF
OK
QUIT
DIVE
NO DEC TIME
MAX
Fig. 4.22. Setting
Options. [3 SET].
QUIT
OPTIONS