SUUNTO VYTEC User Manual
Page 62
60
TOOLS REQUIRED
A flat 1.5 mm screwdriver or a special tool for spring bars (K5857).
Soft cloth for cleaning.
Needlenose pliers or large screwdriver for turning securing ring.
BATTERY REPLACEMENT
The battery and the buzzer are located in the back of the instrument in
a separate compartment, the parts of which are shown in Fig. 5.1. To
change the battery, follow the procedure below:
1. Remove the computer from the console or boot.
Wrist model:
Pull off the boot. Remove it first from the front end with the longer
part of the strap.
Disassemble the shorter part of the strap with a flat 1.5 mm
screwdriver or a special tool for spring bars. The longer part of the
strap may stay on but removing it may ease the work later on.
Console model:
Remove the dive computer from the console according the
instructions of the console.
2. Thoroughly rinse and dry the computer.
3. Open the securing ring of the battery compartment lid by pushing it
down and rotating it clockwise. You may use a pointed nose pliers
or a small screwdriver as an aid in the rotating. Put the pliers ends
into the holes of the securing ring or the screwdriver onto the side
of the right tooth on the ring (Fig. 5.2) and turn the ring clockwise.
Care should be taken not to damage any of the parts.
4. Remove the ring.
5. Carefully remove the lid with the beeper attached to it. The lid can
be removed by pressing with your finger on the outermost edge of
the lid while at the same time pulling with your nail at the opposite
side. Do not use sharp metal objects as they might damage the O-
ring or the sealing surfaces.
6. Remove the O-ring and the battery retainer.
7. Carefully remove the battery. Do not damage the electrical con-
tacts or the sealing surface.
Check for any traces of flooding, particularly between the beeper and
the lid, or for any other damage. In case of a leak or any other damage,
bring the dive computer to an authorized SUUNTO dealer or distributor
for check and repair.