SUUNTO VYTEC - Manual (Page 58)

56
4.3.3.2. Dive Computer Units
Setting [2 UNITS]
To enter the Dive Computer Units Setting
mode, select MODE- 3 SET- 3 SET PREF- 2
UNITS. This will enable you to choose between
metric and imperial units (Fig. 4.34.).
4.3.3.3. Wireless Transmission
Settings [3 HP]
The wireless transmission can be set “ON” or
“OFF” depending on if the optional wireless
pressure transmitter is used or not. No cylin-
der pressure related data is shown or data
reception made when this selection is “off”.
You can set the secondary cylinder pressure
alarm point. The 50 bar alarm is fixed and can-
not be changed. The 35 bar secondary alarm
pressure can be set in the range 10 –200bar. To
set the wireless transmission settings select
MODE- 3 SET- 3 SET PREF- 3 HP
4.3.3.4. Profile Sample Rate
Setting [4 REC]
You can set dive profile sample rate to 10, 20,
30 or 60 seconds. To adjust the sampling rate
select MODE- 3 SET- 3 SET PREF- 4 REC.
The factory default setting is 20 seconds.
4.3.3.5. Dive Computer Model
Setting [5 MODEL] –
AIR/NITROX/GAUGE
In the Dive Computer Model Setting mode the
dive computer can be set to be an AIR com-
puter, NITROX computer or a depth GAUGE
with a timer (Fig. 4.35.).
To enter the Dive Computer Model Setting
mode select MODE- 3 SET- 3 SET PREF- 5
MODEL.
Fig. 4.33. Setting
Backlight On Time.
Press scroll buttons to
change backlight on/off
and to set time value.
Fig. 4.34. Setting Metric/
Imperial units.
OK
TIME
° C
°F
m ft
OK
Fig. 4.35. Setting Dive
Computer model.
OK