Making the vytec personal, Push buttons – SUUNTO VYTEC User Manual

Page 13

The timekeeping display is the default display

of the instrument (Fig. 2.1.). If a button is not

pressed within 5 minutes, the dive computer

beeps and returns to the timekeeping display

automatically (except in Diving and Simula-

tion modes). The timekeeping display shuts

off after two hours, but pressing the PLAN or

TIME button activates it.

Making the Vytec personal

For best use of the Vytec take some time and

make it YOUR computer.
Set the correct time and date. Read this

manual. Set dive alarms and make all the

other settings listed in the introduction in this

manual. Install the Vytec in your console or fit

it on your wrist. If the Vytec is to be used with

the optional wireless pressure transmitter

install it and enable the pressure transmission

in the Vytecs settings. Try the pressure trans-

mission.
Use the dive simulator for getting to know the

dive display
All this so you know your computer and have

it set up as you want it before getting into the

water.

2.2. PUSH BUTTONS

The dive computer has easy-to-use push

buttons and an advisory display, which guides

the user. The SMART (MODE) button is the

key to the system. The two scroll buttons,

PLAN and TIME, are used for scrolling up and

down the menus and to show the alternative

displays. The dive computer is controlled

with these three push buttons as follows

(see Fig. 2.2.).

Fig. 2.1. Time keeping

display. Pressing PLAN

or TIME button activates

display.

Fig. 2.2. Push buttons

of the dive computer.

OPE

Fig 2.3. Depth sensor

(A), water/data transfer

contacts (B).