SUUNTO VYTEC - Manual (Page 17)

15
WARNING:
In case there are several divers using Vytecs with wireless trans-
mission always ensure that all divers are on different codes before
starting the dive.
The selected transmission code can later be
verified via the alternative display, by press-
ing the “TIME” button twice. If needed, the
stored code can be manually erased in this
display by pressing the “PLAN” (up) button
and then pressing “MODE” (select). The
Vytec will now erase the stored code and start
displaying “SETC” allowing a new pairing with
the transmitter.
The alternative display showing the selected
code reverts to the main display after 15
seconds in order to avoid accidental code
changes.
NOTE: In order to save battery energy the
transmitter shuts off if the pressure remains
unchanged for more than 5 minutes and it will
continue transmitting with the saved code
when any pressure change is measured. The
code number is changed if pressure is less
than 10bar [145 psi] at shutoff.
2.4.3. Transmission Data
After the pairing procedure the Vytec will
receive cylinder pressure data from the trans-
mitter. The pressure is displayed in either bars
or psi depending on the unit selection. Any
time the Vytec receives an appropriate signal
it flashes the lightning figure in the display’s
lower left corner. A pressure reading of over 360
bar [5220 psi] will display as “---“ (Fig. 2.6 b).
If the Vytec is unable to receive a valid signal
for more than one minute it will start display-
ing “FAIL” intermittently with the latest valid
pressure reading (Fig. 2.6 c).
Fig 2.6. Pressure
transmission related
displays.
TIME DIVE
m
bar
TIME DIVE
m
bar
TIME DIVE
m
bar
TIME DIVE
m
bar
TIME DIVE
m
bar