beautypg.com

Mandatory safety stop – SUUNTO VYTEC User Manual

Page 24

background image

22

3.2.2. Mandatory Safety Stop

When the ascent rate exceeds 12 meters/min

[40 ft] momentarily or 10 meters/min [33ft]

continuously the micro-bubble build-up is pre-

dicted to be more than allowed for in the de-

compression model. The Suunto RGBM cal-

culation model responds to this by adding a

Mandatory Safety Stop to the dive. The time

of this Mandatory Safety Stop will depend on

the severity of the ascent rate excess.
The STOP sign will appear in the display and

when you reach the depth zone between 6 m to

3 m [20 ft to 10] also the CEILING label, ceiling

depth and the calculated Safety Stop time ap-

pear in the display. You should wait until the

Mandatory Safety Stop warning disappears

(Fig. 3.14.).
The Mandatory Safety Stop time always in-

cludes the three minute Recommended Safe-

ty Stop time. The total length of the Mandato-

ry Safety Stop time depends on the serious-

ness of the ascent rate violation.
You must not ascend shallower than 3 m [10

ft] with the Mandatory Safety Stop warning on.

If you ascend above the Mandatory Safety

Stop ceiling, a downward pointing arrow will

appear and a continuous beeping starts (Fig.

3.15.). You should immediately descend to, or

below, the Mandatory Safety Stop ceiling

depth. If you correct this situation at any time

during that dive, there are no affects on the

decompression calculations for future dives.
If you continue to violate the Mandatory

Safety Stop, the tissue calculation model is

affected and the dive computer shortens the

available no-decompression time for your

TIME

DIVE

m

NO DEC TIME

T

C

B

MAX

bar

Fig. 3.7. Dive has just

begun and no air time is

shown. First estimate of

remaining air time will be

shown after 30-60 seconds.

Fig. 3.8. Diving display.

Present depth is 19.3 m

[63 ft] and no-decompres-

sion stop time limit is 23

minutes in A0/P1 mode.

Maximum depth during this

dive was 19.8 m [65 ft],

elapsed dive time is 16

minutes.

m

NO DEC TIME

T

C

B

MAX

DIVE TIME

MAX

bar

AIR TIME

Fig. 3.9. Diving display. Present cylinder pressure is 210

bar [3045 psi] and remaining air time 41 minutes.

Alternative display of current time and temperature is

shown for 5 seconds after pressing TIME button.

m

NO DEC TIME

T

C

B

MAX

DIVE TIME

MAX

bar

AIR TIME

TIME

°C