beautypg.com

Oxygen displays, Default nitrox settings, And po – SUUNTO VYTEC User Manual

Page 33: It remains in this setting until the o

background image

31

affect oxygen exposure according to the en-

tered O

2

% and PO

2

values. Calculations

based on Nitrox use result in longer no-de-

compression times and shallower maximum

depths than diving with air.
As a safety precaution the oxygen calcula-

tions in the computer are made with an oxy-

gen percentage of 1% + setO

2

% .

When the dive computer is set in Nitrox mode

the Dive Planning and Dive Simulation modes

both calculate with the O

2

% and PO

2

values

that are currently in the computer.
To set the Nitrox mixes refer to chapter 4.3

Set Modes.

DEFAULT NITROX SETTINGS

In Nitrox mode the Vytec allows the user to set

1-3 nitrox mixes containing 21-99% oxygen.
In the Nitrox mode, the default setting for

MIX1 is standard air (21% O

2

). It remains in

this setting until the O

2

% is adjusted to any

other percentage of oxygen (22% - 100%).

The default setting for maximum oxygen par-

tial pressure is 1.4 bar, however you are able

to set it in the range of 0.5 - 1.6 bar.
If unused, the computer will retain the manu-

ally entered values for the oxygen percentage

and maximum oxygen partial pressure for

MIX1 for about two hours, after which it will

revert to the default settings.
MIX2 and MIX3 are by default set to OFF. To

set MIX2 and MIX 3 refer to chapter 3.4.4 Gas

change and multiple breathing mixes. Oxygen

percentages and maximum oxygen partial

pressures for MIX2 and MIX3 are stored per-

manently.

3.4.2. Oxygen Displays

If set to Nitrox mode the NITROX display, with

all labeled oxygen information and the label

NITROX, is shown after activation. In Dive

Fig. 3.19. Decompression

dive, above ceiling.

Note downward pointing

arrow, Er warning and

an audible alarm. You

should immediately

(within 3 minutes)

descend to or below

ceiling.

DIVE TIME

T

C

B

m

STOP

CEILING

ASC TIME

AIR TIME

bar

Fig. 3.20. Ceiling and

Floor Zones. The

Recommended and

Manadatory Safety Stop

zone lies between 6m

and 3m [20 ft and 10ft].

3m / 10ft

6m / 18ft

CEILING

FLOOR

Fig. 3.21. Nitrox display.

Maximum depth based

on set O2% (21%) and

PO2 (1.4 bar) is 54.1 m

[177 ft].

PO2

O2%

OLF

m