Neuspeed 49.10.93 - Manual (Page 13)

Page 13
GOLF IV, JETTA IV
LOCATION AND REMOVAL OF ECU
1. Open engine hood. ECU is located under plastic cover at base of windshield.
2. Remove four T-20 Torx or Phillips head screws on the passenger side and remove plastic cover.
3. Remove the plastic caps that cover the nuts on the windshield wiper arms.
4. Remove the 13mm nuts that hold on the windshield wipers. Lift wipers up and wiggle to remove.
5. Starting on the passenger side, lift plastic cover perpendicular from the glass to release cover out of its
locking groove. Continue toward driver’s side to fully remove cover.
6. The ECU is located in the middle Remove the two electrical connectors by firmly holding the slide clip
and pulling it out toward the side of the car. This action will unlock the connector and release it from
the ECU. DO NOT try to force the connector off the ECU. Just pull the locking slid outward from the
connector sideways. Then pull the connector away from the ECU.
7. On the passenger side of the ECU, there is a metal clip. Take a flat screwdriver and pry outwards to
unlock the ECU. Now pull ECU out.
8. When sending your ECU to NEUSPEED®, wrap it carefully in bubble wrap or equivalent, package
securely, include your receipt for correct program, and send next day air insured for full value…
$1,200.00 to: NEUSPEED®, 3300 Corte Malpaso, Camarillo, CA 93012. MARK BOX: ATTN: CHIP
9. We will receive your ECU the following business day, perform the NEUSPEED® P-Chip installation,
and ship it back to you the same day. Upon return of your ECU, reinstall in reverse of disassembly.
SEE STEP #37.