Neuspeed 25.02.25.4 User Manual
Neuspeed For the car

NEUSPEED
• 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
www.neuspeed.com
25mm RACE SERIES TUBULAR REAR ANTI-ROLL BAR – PART #25.02.25.4
FITS: 2006-up AUDI A3(8P) QUATTRO, 2008-up AUDI TT(8J) QUATTRO
2008 VW R32, 2006-09 VW PASSAT(B6) 4-MOTION, 2009-up VW CC 4-MOTION, 2009-10 VW TIGUAN FWD, 2009-up VW TIGUAN 4-MOTION, 2012 VW Golf R
PARTS LIST:
1 – TUBULAR ANTI-ROLL BAR
TOOLS REQUIRED:
1 – RATCHET
1 – PKG. SILICONE GREASE
1 – M10 TRIPLE SQUARE (12 POINT) OR 8mm HEX KEY WRENCH
2 – POLYURETHANE BUSHINGS
1 – M6 TRIPLE SQUARE (12 POINT) OR 5mm HEX KEY WRENCH
1 – 16mm WRENCH
1. Park car on a flat and level surface
capable of supporting the vehicle’s
weight on jack and jack stands. Using
the
manufacturer’s
recommended
lifting point(s), raise rear of vehicle
and support with jack stands. NEVER
WORK ON A VEHICLE SUPPORTED
ONLY WITH A JACK!
2. Disconnect end-links from original anti-
roll bar by securing stud with M6 Triple
Square or 5mm hex key wrench and
loosening nut with 16mm wrench.
3. Remove four bushing clamp mounting
bolts using a M10 Triple Square or
8mm hex key wrench. Now remove
original anti-roll bar from vehicle.
NOTE: To access upper clamp bolts,
suspension must be compressed to
raise drive axel.
4. Apply silicone grease to the inside of
supplied bushings and install on the
inside of stop washer on NEUSPEED
anti-roll bar.
5. Install NEUSPEED anti-roll bar using
original clamps and bolts to sub-frame.
Torque bolts to 20Nm (15 ft-lbs).
6. Attach end-links to NEUSPEED anti-roll
bar using original nuts. Note: The
end-link to anti-roll bar bolt is easier to
install with suspension loaded. Torque
to 40Nm (30 ft-lbs). Forward hole is
softer setting; rearward hole is stiffer
setting (more oversteer).
7. Double check complete installation and
TEST DRIVE CAREFULLY!
Copyright 2012, NEUSPEED
®
. All rights reserved.
Reproduction in whole or in part prohibited.
DOC.25.02.25.4 Rev. 06.18.12