Neuspeed 62.02.68 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
www.neuspeed.com
POWER PULLEY KIT
2008.5-12 AUDI A4(B8), A5 and Q5(8R) 2.0L TFSI
With Hydraulic Power Steering Pump
PART # 62.02.68
INSTALLATION INSTRUCTIONS
PART LIST: 1 – CRANKSHAFT PULLEY 1 – BELT
1 – CRANKSHAFT BOLT
TOOLS REQUIRED: 1 – 17mm Wrench 1 – Ratchet Wrench
1 – 7mm Socket 1 – VW Tool T10355 Counter Holder
1 – Phillips screwdriver 1 – Torque Wrench
1 – 24mm Socket 1 – Long Handle Breaker Bar
1 – Mirror
NOTE: FACTORY TOOL REQUIRED AND PROFESSIONAL INSTALLATION RECOMMENDED.
1. Car Hoist required, vehicle not high enough from
ground with a jack or jack stands.
2. Remove lower engine splash guard. Undo the
dowel pins using a Phillips screwdriver. A4
shown, models may vary.
3. Using 7mm socket unbolt and remove electric
fan control module.
4. Disconnect electrical connectors at both electric
fans; pull harness out of retaining groove at let
hang.
5. Before removing ribbed belt, mark running
direction with marking pen if the stock belt and
pulley is ever to be re-installed.
6. Using a 17mm wrench, rotate spring loaded idler
pulley downwards to release tension and remove
ribbed belt. Now slowly release belt tensioner.