Neuspeed 65.02.67 - Manual

NEUSPEED® • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX •
[email protected] • Visit us on the web… http://www.neuspeed.com
PARTS LIST: TOOLS REQUIRED:
1 – P-FLO BRACKET 1 – INTAKE TUBE 1- SILICONE REDUCER HOSE 1 – NEUSPEED AIR FILTER SCREWDRIVER PHILLIPS SCREWDRIVER 5mm HEX KEY WRENCH
1 – SS #52 HOSE CLAMP 1 – SS #56 HOSE CLAMP 4 – SS CAP BOLT M6x12mm 4 – SS M6 NYLOC NUT 6mm HEX KEY WRENCH 10mm WRENCH 11mm WRENCH
1 – SS ACORN NUT 1 – SERRATED FLANGE NUT 1 – SUPPORT BRACKET - Short 1 – RUBBER ISOLATOR RATCHET DRIVER 10mm SOCKET T25 TORX
1 – WEATHER STRIPPING 1- SUPPORT BRACKET - Long SPRING CLAMP PLIERS DRILL ¼” DRILL BIT
1. Remove air intake duct at radiator support. There are (2)
T25 Torx screws on top of support.
2. Unclip sound amplifier hose attached to air filter box lid.
3. Disconnect electrical connector at MAF sensor.
4. Using spring clamp pliers, disconnect air intake tube from
MAF sensor.
5. Unbolt left front corner of lower air box using 5mm hex key
wrench.
6. Remove air box lid using Phillips screwdriver then air filter.
7. Lift off lower air box from the two rubber mounting
grommets and remove from vehicle. Use WD-40 or
equivalent on grommets to ease removal.
8. Install and tighten supplied rubber isolator onto left front air
box mounting bracket.
9. Using 10mm socket, temporally remove the front bolt on air
box mounting bracket.
10. Install supplied support bracket to air box mount using
original bolt (from step 9), then to stud on underside of
mount for rubber grommet using supplied M6 flange nut.
Now tighten nut and bolt.
P-FLO KIT AIR INTAKE SYSTEM – PART #65.02.67
Fits: 2009-11 Audi TTS