Neuspeed 15.02.25.3 - Manual

NEUSPEED® • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX •
[email protected] • Visit us on the web… http://www.neuspeed.com
25MM RACE SERIES TUBULAR FRONT ANTI-ROLL BAR – PART #15.02.25.3
Fits 2006-up Audi A3(8P) FWD, 2008-09 Audi TT(8J) FWD, 2006-up VW EOS, GTI MKV/VI, Jetta V/VI, Rabbit & Tiguan FWD
PARTS LIST: TOOLS REQUIRED:
1 – 25mm TUBULAR ANTI-ROLL BAR 1 – SILICONE GREASE 1 – T25 TORX 1 – RATCHET 1 – 10mm SOCKET 1 – 13mm SOCKET
2 – U-CLAMP w/BASE 2 – URETHANE BUSHINGS 1 – 16mm SOCKET 1 – 18mm SOCKET 1 – 18mm WRENCH 1 – WD-40
1. Park vehicle on a flat, level surface
capable of supporting the vehicle’s
weight on a jack and jack stands. Using
the manufacture’s recommended lifting
point(s), raise front of vehicle and
support with jack stands. NEVER
WORK ON A VEHICLE SUPPORTED
ONLY WITH A JACK!
2. Remove lower engine splash pan (8)
T25 Torx screws.
3. Unbolt torque arm from transmission
housing (2) 16mm hex bolts and
exhaust down-pipe support bracket from
rear of aluminum sub-frame (2) 13mm
hex bolts.
4. Unbolt and remove aluminum sub-frame
from vehicle:
(4) 16mm hex bolts [Steering Rack]
(4) 13mm hex bolts [Bushing Clamps]
(4) 18mm hex bolts [Sub-frame Mount]
The two rear sub-frame bolts are
special, do not mix. Please see bolt
location photo at end of document for
bolt identification and locations.
5. Unbolt anti-roll bar from end-links
18mm hex nut.
6. Driver’s side of vehicle: Unbolt plastic
wire guide from aluminum control arm
mount 10mm hex bolt.
7. Unbolt aluminum control arm mount
from uni-body and let swing down.
NOTE: Because of enlarged mounting
holes, use marking pen to mark location
of control arm mount to uni-body. This
will aid in keeping the original
alignment.
8. Remove original anti-roll bar. Pull out
driver’s side first, then lift up steering
rack on passenger’s side to ease
removal.
9. With supplied grease, lubricate inside of
supplied urethane bushings. Install
bushings onto NEUSPEED anti-roll bar
just inside of stop washers.