Neuspeed 49.10.93 - Manual (Page 11)

Page 11
MASS AIR FLOW
SENSOR
AIR BOX
AIR INTAKE HOSE
EXPANSION TANK
TO HEATER
TO ENGINE
TO RADIATOR
BODY
THROTTLE
COOLANT SCHEMATIC
FUEL PRESSURE
REGULATOR
EVAP CANISTER
PURGE VALVE
5/16 T-FITTING
LEAK DETECTION
PUMP
BYPASS
VALVE
AIR PUMP
FUEL INJECTION AIR ASSIST
CHECK VALVE
MASS AIR FLOW
SENSOR
THROTTLE BODY
CHECK VALVE BRAKE BOOSTER
AIR BOX
AIR INTAKE HOSE
PCV HEATING
ELEMENT
VACUUM SCHEMATIC
PCV
34. Reconnect battery. BEETLE ONLY: Re-install upper front strut tie-bar.
35. Clean front plastic radiator cover, and apply your NEUSPEED Exemption Plate, and Belt Path routing decal. Then apply the
supplied Premium Fuel Only decals to fuel door and over factory lettering on fuel gauge.
36. Clean area, align carefully and apply NEUSPEED Supercharger badge to rear hatch, trunk lid or your preference.
37. When you receive your ECU, re-install in reverse of disassembly, and reconnect battery cable. DO NOT START ENGINE YET!
Turn ignition key to ON position, wait for 30-seconds and then you can start engine. The throttle body MUST be given time to
adapt to the ECU.
38. Double check complete installation, tightness of all nuts and bolts, and TEST DRIVE CAREFULLY!
39. NOTE: If you are not already using premium fuel, drive under very low boost until your tank is just about empty and fill with
premium fuel. Max boost can now be used.