Neuspeed 25.02.19.9 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
Visit us on the web…http://www.neuspeed.com & http://www.apsoutlet.com
7/8” (22mm) REAR ANTI-ROLL BAR
FITS VW GOLF IV R32
PART # 25.10.22.8
INSTALLATION INSTRUCTIONS
PARTS LIST:
1 – ANTI-ROLL BAR 1 – PKG. SILICONE GREASE
2 – BUSHINGS 2 – M10 NYLOC NUTS
TOOLS REQUIRED: 1 – RATCHET 1 – 17mm WRENCH
1 – 6” EXTENSION 1 – SMALL SCREWDRIVER
1 – 13mm SOCKET 1 – TORQUE WRENCH
1 – 16mm WRENCH
1. Park car on a flat, level surface capable of supporting the vehicle’s weight on jack and jack stands.
2. Using the manufacturers recommended lifting
point(s), raise rear of vehicle and support with jack
stands. NEVER WORK ON A VEHICLE
SUPPORTED ONLY WITH A JACK!
3. Loosen exhaust clamp (17mm Hex) and disconnect
exhaust from catalyst. Disconnect left and right exhaust
hangars and vacuum hose from diaphragm.
4. Remove exhaust from vehicle.
5. Using a small screwdriver, remove fasteners
securing heat shield and remove heat shield.