Muse Research Receptor manual v1.2 - Manual (Page 57)

5: View Buttons in Depth 57 Receptor Manual
MIX: Send 1 Level
Rotate the top display knob to select the Send 1 Level parameter. This parameter controls how much of the
signal is sent to Effects Bus 1 (whose effect chain is configured in the B1 channel).
0 1 S e n d 1 L e v e l < >
III III 6 4
Rotate the bottom knob to set the level (0-127). Send levels change instantly, meaning you’re not required to
push the bottom display knob to apply the change.
SHORTCUT: When the Send 1 Level parameter is visible, you can press the bottom display knob to quickly set
it to zero.
MIX: Send 1 Pre/Post
Rotate the top display knob to select the Send 1 Pre/Post parameter. This parameter determines whether
the signal is routed to the effects bus before (pre) or after (post) going through the channel volume. If the signal
is
Post Fader , then changing the Volume level changes the amount of effected signal proportionately. If the
signal is Pre Fader , then the Send Level and Volume levels act independently. This is useful if, for example,
you wish to hear only an effected signal with no dry signal, which you would accomplish by setting this
parameter to
Pre Fader and the Volume level to zero.
0 1 S e n d 1 P r e / P o s t < >
III III P o s t F a d e r
Rotate the bottom display knob clockwise to select
Pre Fader
. Rotate the bottom display knob counter-
clockwise to select Post Fader . The change happens instantly, meaning you’re not required to push the
bottom display knob to apply the change.
SHORTCUT: Pressing the bottom display knob toggles between Pre and Post Fader.
MIX: Send 2 Level
Rotate the top display knob to select the
Send 2 Level
parameter. This parameter controls how much of the
signal is sent to Effects Bus 2 (whose effect chain is configured in the B2 channel).
0 1 S e n d 2 L e v e l < >
III III 5 1
Rotate the bottom knob to set the level (0-127). Send levels change instantly, meaning you’re not required to
push the bottom display knob to apply the change.
SHORTCUT: When the Send 2 Level parameter is visible, you can press the bottom display knob to quickly set
it to zero.
MIX: Send 2 Pre/Post
Rotate the top display knob to select the
Send 2 Pre/Post
parameter. This parameter determines whether
the signal is routed to the effects bus before (pre) or after (post) going through the channel volume. If the signal
is
Post Fader , then changing the Volume level changes the amount of effected signal proportionately. If the