Philips 28PW778A - Manual (Page 8)

... preparation
OBii
S
Cat.
QX>
Preparing your remote control
2
Remove the battery
cover at the back of
your remote control.
Insert two batteries
(Type AAA, 1.5 V) into
the compartment.
Note :
• Remove the batteries from the remote control if you do not use it for an extended period. This is
to prevent possible damage due to battery leakage.
• Make sure that there is no obstruction between the remote control and the television.
• Do not use old and new batteries together.
Switch on your television
• Press the power knob © button on the front, bottom left of your television.
A green or red indicator light appears.
green light red light
If the indicator light is GREEN, it means:
Your television is switched ON. Wait a few seconds for the screen to light up. If no signal input is
detected, you will see a blue screen with the word "PHILIPS".
If the indicator light is RED, it means:
Your television is switched on but the screen stays dark. Your television is on 'standby'.
• Press any digit button, CH + or — button, A/CH button, (¡) button or VIDEO button on
your remote control.
The screen lights up. If no signal input is detected, you will see a blue screen with the word
"PHILIPS".
Note : If there is no signal detected after about 10 minutes, your television will switch over to
standby. ________________
8