Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 63)

Appendix A: Reporting codes
NX-6V2 Control Panel Installation Manual 59
Reporting Ademco Contact ID transmissions
The NX-6V2 has the ability to report Ademco Contact ID transmissions. Each
report in Contact ID consists of an event code and a zone ID (the number of the
zone that is in alarm). The event codes are described in the following table and
are programmed in the zone type event code (Locations 110 to 169).
Table 14: Reporting Ademco Contact ID transmissions
Event code Contact ID Description
0 122 Silent panic
1 110 Fire alarm
2 120 Panic alarm
3 130 Burglary alarm
4 131 Perimeter alarm
5 132 Interior alarm
6 133 24-hour burglary
7 134 Entry alarm
8 135 Day/night alarm
9 150 Nonburglary 24-hour
10 121 Duress alarm
11 100 Medical alarm
12 123 Audible panic alarm
13 137 Tamper alarm
14 602 Periodic test
15 151 Gas detected
16 158 High temperature
17 154 Water leakage
18 140 General alarm
19 140 General alarm
20 159 Low temperature alarm
21 158 High temperature alarm
22 115 Manual fire alarm