Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 27)

Chapter 2: Reporting codes
NX-6V2 Control Panel Installation Manual 23
Location 13 - Phone 3 account code
Location 13 has six segments of numerical data. Use this location to program the
account code sent when phone 3 is dialed. The default for each segment is 10.
Program a 10 in the segment immediately after the last digit of the account code.
If the account code is six digits long, program all six segments. If Location 6 -
Phone 2 is left unprogrammed, use account code 1 when phone 3 is dialed.
Location 14 - Phone 3 communicator format
Location 14 has one segment of numerical data. Use this location to program the
communicator format used to transmit to the receiver connected to phone 3.
Refer to your central station receiver documentation to determine which format is
compatible. Table 6 on page 18 describes the formats for this location. If you
need a format other than those listed, review the override options described in
Location 18. Program a 15 to create a special format (in addition to the entries in
Location 18). The default is 0. If this location contains a 0, format 1 will be used
when phone 3 is dialed.
Location 15 - Phone 3 dial attempts/backup control
Location 15 has two segments of numerical data.
Segment 1 - Phone 3 dial attempts. Program the number of dial attempts (1 to 15) the
communicator makes to phone 3 before ending the notification process. The default is 8, which
means that the communicator makes eight attempts to the first number.
Segment 2 - Phone 3 backup control, Program the backup control for phone 3. The default is 0.
0 = The NX-6V2 will make the designated number of attempts to phone 3 before setting the fail to
communicate condition to stop reporting.
1 = The NX-6V2 will stop trying to communicate after the designated number of attempts have
been made to phone 3.
2 = The NX-6V2 will make the dial attempts in increments of two. The first two attempts are made
to phone 3, the next two attempts to phone 2. This repeats until the total number of attempts
designated in segment 1 is completed.
Location 16 - Phone 3 events reported
Location 16 has two segments of feature selection data. Use this location to
select those events reported to phone 3.
• If you do not want dual or split reporting, use the default of 0.
• If you want dual or split reporting and the split is based on the event type
(alarm, open/close, etc.), use only those events that are reported to phone 3.
• If you don’t want events reported to phone 3, program 0 in Location 16.