Heli-Max HMXE0250 - Manual (Page 30)

❏
2. Turn on the transmitter and receiver. Move the collective
stick to full throttle. Place the pitch gauge on the blade as
shown and set it to +10°. Align the top (or bottom) of the pitch
gauge with the flybar. If necessary, adjust the long linkage
between the mixer and the swashplate. Once the correct pitch
has been established, adjust the length of the linkage on the
opposite side to match.
❏
3. On your transmitter, place the throttle/collective stick in
the center. Verify that the setting is around +4.5°. If the pitch is
off, adjust Point #3 in the pitch curve on your radio. If you adjust
Point #3, adjust Points #2 and #4 to maintain a smooth curve.
❏
4. Lower the throttle/collective stick on the transmitter to
the bottom. Verify that the setting is around –2°. Use pitch
curve Point #1 if adjustments are needed. Once you are
finished, set Point #2 to keep an even curve.
❏
5. Repeat the pitch curve setup for the Hold function and
any other Idle Ups you may need.
FUEL LINES
❏
Cut a piece of 4" [102mm] fuel line for the carburetor
pickup line and install. Use the remaining fuel line for the
pressure line to the muffler.
MUFFLER INSTALLATION
❏
Install your muffler following the manufacturer’s instructions.
Mounting hardware should be included with the muffler.
BODY AND MOUNTS
❏
1. Slide the threaded rod through the frame. Using thead
locking compound, install the body mounts as shown above.
FINAL ASSEMBLY
30