Heli-Max HMXE0250 - Manual (Page 21)

21
END POINT ADJUSTMENTS
6EXH
7CH
9CH
❏
Futaba T6EXH: Select the [EPA] menu and set CH1 and
CH2 to 110 % (left/right and forward/aft).
❏
Futaba T7CH: Select the [EPA] menu and set CH1 and
CH2 to 110 % (left/right and forward/aft).
❏
Futaba T9CH: Select the [EPA] menu and set CH1 and
CH2 to 110 % (left/right and forward/aft).
SUB-TRIM
If possible, sub-trim should be avoided. Most servo arms are
designed with an odd number of splines which allows you to
rotate it 90° or 180° and change the center position of the
arm. If you cannot get the arm perfectly straight, then a
small
% of sub-trim may be used but it is best to avoid using
it. Sub-trim can decrease the available throw one direction.
FAIL-SAFE
6EXH
7CH
9CH
This function is only available for PCM receivers and cannot
be used on FM. What fail-safe provides is a set of commands
for the servos to follow if the receiver should experience
interference for more than two seconds. Please set the
throttle [FAIL SAFE] to bring the engine back to idle and
leave all other servos set to [HOLD]. This will help to prevent
damage in the case of severe interference.
GYRO FUNCTION
6EXH
7CH
9CH
The gyro function is only used on gyros that have a remote
gain that plugs into the receiver. If your gyro does not have
remote gain, please follow the instructions provided with the
gyro and set it up for heading hold mode.
❏
Futaba T6EXH: Select the [GYRO] menu. Enable the
function and set the gain to +60 % .