FXpansion DCAM Synth Squad Operation Manual - Manual (Page 10)

10
Controlling parameters: initial values (Main view)
When the ‘Main’ view is selected, only the initial value of a control can be adjusted.
The initial value of a
control is adjusted by
clicking it and dragging
up/down.
Main view:
Sliders Main view:
Rotary pots
The initial value of a
control is adjusted by
clicking it and dragging
up/down.
You can also double-click the control, type a value and
press ENTER or RETURN.
Main view
Fine control over parameters
Hold down the SHIFT key while adjusting a control for finer resolution.
Controlling parameters: TransMod modulation depths
Each synth features 8 TransMod slots, which allow modulation depths to be set on almost all synth parameters.
When a TransMod slot is selected (see below), the synth’s controls can be adjusted in the following ways:
You can also double-click
outside the slider cap,
type a value and press
ENTER or RETURN.
Click outside the slider cap and
drag up/down.
The slider cap divides and the
modulation depth from the initial
value is set.
You can also move the part of the
slider cap with the arrow to adjust
modulation depth.
TransMod slot selected:
Setting modulation depth
Click the slider cap and drag
up/down, or double-click to type
a value and press ENTER or
RETURN.
TransMod slot selected:
Setting initial value
Drag the initial part of the slider cap
(without the arrow):
The initial value and the modulation depth
are adjusted together.
You can also double-click to type a value.
TransMod slot selected:
Setting initial value + depth
Hold down ALT and click/drag the initial
slider cap (without the arrow):
Only the initial value is set – the
modulation depth is unaffected.
TransMod slot selected:
Setting initial value only
Sliders
• When modulation already exists, 2 additional ways of manipulation are possible:
TransMod slot selected:
Setting initial value only
Hold down ALT and click/drag the centre
of the pot:
Only the initial value is set – the modula-
tion depth is unaffected.
TransMod slot selected:
Setting initial value + depth
Click and drag the centre of the rotary pot
to adjust the initial value and modulation
depth together.
You can also double-click to type a value.
You can also double-click
in the outer ring, type a
value and press ENTER
or RETURN.
TransMod slot selected:
Setting modulation depth
Click and drag the outer ring
around the rotary pot to set the
modulation depth from the initial
value.
TransMod slot selected:
Setting initial value
Click the centre of the
rotary pot and drag up/down.
Rotary pots
• When modulation already exists, 2 additional ways of manipulation are possible: