EVCO EVX815P7 Installer manual - Manual (Page 61)

EVCO S.p.A. EVX 800 range | Installer manual ver. 1.2 | Code 144X800E124
page 61 of 66
14 TECHNICAL DATA
14.1 Technical data
Purpose of the devices: blast chiller controllers
Esecuzione: open frame board
Dimensions:
EVX802 EVX812 EVX805 EVX815
156.0 x 45.0 x 44.2 mm (6.141
x 1.771 x 1.740 in; L x H x D).
156.0 x 45.0 x 48.7 mm (6.141
x 1.771 x 4.869 cm; L x H x D).
Installation: back panel via M3 studs
Protection rating: IP00
Connections:
6.3 mm faston (0.248 in, power supply and outputs), screw
terminal board (inputs), 6 pole connector (serial port).
Temperature of use: from 0 to 55 °C (from 32 to 131 °F)
Storage temperature: from -25 to 60 °C (from -13 to 140 °F)
Humidity for use: from 10% to 90% relative humidity without condensate
Pollution situation: 2
Power supply:
EVX802 EVX812 EVX805 EVX815
230 VAC (±10%), 50/60 Hz,
2.3 VA max. or 115 VAC
(±10%), 50/60 Hz, 5 VA max.
230 VAC (±10%), 50/60 Hz,
2.8 VA max. or 115 VAC
(±10%), 50/60 Hz, 5 VA max.
Overvoltage category: III
Clock:
EVX802 EVX812 EVX805 EVX815
not available.
incorporated
(with
condenser)
not available.
incorporated
(with
condenser)
Battery autonomy in the event of a power-cut: 24 h with battery
fully charged
Battery charging time: 2 min (the battery is charged by the device
power supply)