Dscp-queue mapping – Comtrol ES9528-XT User Guide User Manual
Page 95
RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G
DSCP-Queue Mapping - 95
Configuration Using the Web Interface
After configuration, press Apply to enable the settings.
Note: You must Save the settings (
), if you want to maintain these settings if the ES9528 is powered
off.
DSCP-Queue Mapping
Use this page to change DSCP values to Physical Queue mapping table. Since the switch fabric of the ES9528
only supports four queues. Lowest, Low, Middle and High users should therefore assign how to map DSCP
values to the level of the physical queue. You should therefore assign how to map DSCP value to the level of
the queue. You can change the mapping table to follow the upper layer 3 switch or routers’ DSCP setting.
After configuration, press Apply to enable the settings.
Note: You must Save the settings (
), if you want to maintain these settings if the ES9528 is powered
off.