Comtrol ES9528-XT User Guide - Manual (Page 63)

RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G Port Configuration - 63
Configuration Using the Web Interface
Port Configuration
The Port Configuration group allows you to enable/disable port state, or configure port auto-negotiation,
speed, duplex, flow control, port aggregation settings (port trunking), and rate limit control. It also allows you
to view port status and aggregation information. The following pages are included in this group:
• Understanding the Port Mapping
• Port Control
• Port Status on Page 65
• Rate Control on Page 66
• Storm Control on Page 67
• Port Trunking on Page 68
Optionally, you can use the CLI for configuration, see Port Configuration (CLI) on Page 145.
Understanding the Port Mapping
Before configuring the port settings, you should first understand the port numbers in the ES9528.
There are 24 Fast Ethernet ports. In the web user interface, choose the port number you want to configure,
the available number from port 1~28. Ports 1-24 represent Fast Ethernet ports. In the CLI, use fa1, fa2…fa24
to represent Port 1 to Port 24.
Gigabit/Combo ports always use Port 25, 26, 27 and 28. In the CLI, use gi25, gi26, gi27 and gi28 to represent
Ports 25-28.
Port Control
Port Control page allows you to enable/disable port state, or configure the port auto-negotiation, speed,
duplex, and flow control.
Select the port you want to configure and make changes to the port. The following table provides information
about the different port control options.