Comtrol ES9528-XT User Guide - Manual (Page 107)

RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G IP Filter - 107
Configuration Using the Web Interface
Highlight an IP Filter ID/Name and click Edit to configure the IP Filter Rules.
Filter Type: IP Standard/Extended
Filter ID/Name The ID or the name for this IP Filter entry.
Action
Select Permit to permit traffic from specified sources and Deny to
deny traffic from those sources.
Source/Destination Address Type the source/destination IP address you want configured.
Source/Destination Wildcard
You can define a single host or
a group of hosts based on the
wildcard. Some of the
allowance examples are shown
in the following table.
Protocol
Select a protocol that you want associate with the filter. The field
includes IP, TCP, UDP or ICMP type.
Destination Port TCP/UDP port of the Destination Port field.
Egress Port Bind this Filter to selected egress port.
Add Adds the rule to the Filter.
Remove Removes the selected rule from the Filter.
Modify Allows you to edit the rule which you selected.
Reload Reloads the rule table.