Toshiba MA-136-100 SERIES - Manual (Page 71)

SETTING THE LISTING CAPACITY OF DEPARTMENT (Condition: after an AUTO SCAN RESET)
Mode Lock: SET Key Operation
*(Note 1)
t2j [x] IHALCI ^ 1AT/TLI ... for the common listing capacity
for all the departments
*CNote 1)
l2|
[X]
I
HALC i ->
I
DEWI -> [ AT/TL 1 ... for individual departments'
L
I listing capacities
Repeat until all-*
the required indiv.
dept. Listing Capacities
are set.
♦Note 1: HALC .... Might Amount Listing Capacity
' A '
•Number of maximum digits allowed
-Maximum value of the top digit .allowed
ex.) (3 i 4 I ... indicates 3999
U . . l b
4 digits ”
^Value of the
top digit
The amount range allowed
to enter will be:
Equal to or smaller than
the HALC (3999 in this case)
NOTES: 1. If the individual listing capacity of a department has been
set, it prevails over the common listing capacity of all the
departments.
2. To reset an individual listing capacity, enter "0" before the
[DEPTI key in the above operation. Then the common listing
capacity of all the departments, if pre-programmed, will
prevail.
SETTING THE PRESET RATES OF AND KEYS (Condition: anytime outside a
sale)
Mode Lock SET Key Operation
1) To set a rate of integral value:
1 RATE 1 ■ + g+]
I RATE \ ^ \% ^
2) To set a rate containing the decimal point:
I Integral Portion | [T] I Decimal Portion j | %+ \
max. 2 digits max. 3 digits } r^—i
(up to 99.999%)
3) To reset the rate once set:
|ol 113
|o! [E3
- 26 -