Toshiba MA-136-100 SERIES User Manual

Page 35

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING THE LISTING CAPACITY OF DEPARTMENT (Condition: after an AUTO SCAN RESET)

Mode Lock: SET Key Operation

*(Note 1)

|2| IXl IHALCI > IAT/TLI ... for the common listing capacity

for all the departments

*tNote 1)

(2j -> [x]

I HALC I I DEPT |

•> \

AT/TL | ... for individual departments'

listing capacities

Repeat until all**
the required indiv.
dept. Listing Capacities

are set.

♦Note 1: HALC .. Hight Amount Listing Capacity

Number of maximum digits allowed

■Maximum value of the. top digit-allowed

ex.) l3|4|

4 digits —

-Value of the

top digit

indicates 3999

The amount range allowed

to enter will be:

Equal to or smaller than

the HALC (3999 in this case)

NOTES: 1. If the individual listing capacity of a department has been

set, it prevails over the common listing capacity of all the
departments.

2. To reset an individual listing capacity, enter "0" beioi'e the

[pE^tI key in the above operation. Then the common listing

capacity of all the departments, if pre-programmed, will
prevail.

SETTING THE PRESET RATES OF AND

KEYS (Condition: anytime outside a

sale)

Mode Lock SET

Key Operation

1) To set a rate of integral value:

I RATE I -» dg

I RATE I

2) To set a rate containing the decimal point:

I Integral Portion! [Tl [Decimal Portion]

\%+\

max. 2 digits

max. 3 digits

(up to 99.999%)

3) To reset the rate once set:

i o | ^ d 3

| 0 | ^ E

- S I -

This manual is related to the following products:

MA-136