Toshiba MA-136-100 SERIES User Manual
Page 69
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PROGRAMMING TAX TABLE (Condition: after an AUTO SCAN RESET)
Mode Lock; SET
1) TAX 1 FULL BREAKS
Key Operation: |max. amount non-taxable] —> ITXl/MI
¡max, amount for tax levied] j
TXl/M
I
¡max, amount for
2.j.
tax levied] —»i
TXl/M
I
Repeat until the "A" Break is entered.
[max, amount for Ngj tax levied [—»fTXl/M
I ...
”A'^ Break
[ST
I
(to indicate the "A" Break entry)
¡max, amount for N+lgi tax levied¡—»|TXI/
m
I
¡max, amount for N+2g( tax levied |—»|
fxi/Ml
Repeat until the ”B" Break is entered,
¡'
a
W^ (to end)
NOTE: The amount entry may be maximum 4-digit value (up to 9999(i}.
2) TAX 1 *'A’* BREAK AND
%
RATE COMBINATION
Key Operation: First set the "A" Break following the same operation
up to the "A" Break entry and the
I
ST| key depression
in "1) TAX 1 FULL BREAKS'* above.
1 TAX RATE applied when exceeding the "A" Break amount
(max. 4 digits, up to 99.99%. Do not use the [Tl
key. The fraction of the amount resulted from this
%
rate calculation will be rounded off.)
I
fAT/Tin (to end)
3) TAX 1
%
RATE ONLY
Key Operation: 10i lYxi/MI
1~ST1 —► j TAX RATE | —>|~AT/TL |
(The conditions
of the rate are
the same as the
above TAX RATE.)
NOTES: 1. If only one tax modifier key (
I TX/MI
) is installed on the key
board, use the 1
TX/M
| in place of the FlXl/Ml in the descrip
tion 1) , 2), or 3) above.
- 24 -