Toshiba MA-136-100 SERIES - Manual (Page 26)

READ(X) AND RESET(Z) REPORTS
The following table shows the key operation to take each report and its
content. The "X" and "Z" reports have the exactly the same content printed,
except that:
1. The "X” reports allow to read the totals but not clear memories, while
"Z" reports allow to read the totals and at the same time all the
resettable memories will be cleared when the reports have been issued.
2. The symbol "X" is printed on the top line of a "X" report, while ”Z"
is printed on a "Z" report, to indicate the type of report.
3. A reset count is printed on the bottom of a "Z" report.
TABLE OF X AND Z REPORTS
(REPORT NAME) (KEY OPERATION) (CONTENT & REMARKS)
AUTO SCAN READ
AUTO SCAN RESET
PLU READ
PLU RESET
Mode Lock: X -»
Mode Lock: Z
Mode Lock: -X ->
Mode Lock: Z ->
All DEPT and Transaction
-»I AT/TL1 Totals and Counters that
have memories opened.
All the totals of PLUs
I PLU I that have been se t. The
Z report will clear only
the sales quantity but
not the preset prices.
In the X report, PLUs
with no sales data record­
ed will not be printed.
PRESET-DATA VERIFICATION Mode Lock: X
1
2
DEPT Preset Prices
DEPT L.C., Tax Status,
Pos./Neg. Status
PLU Codes, Preset Prices,
Link Depts
% Preset Rates, Common LC
NOTES: 1. The cash drawer will open when final key to start each report print­
ing is depressed except on the PRESET DATA VERIFICATION.
2. The display stays to indicate "0" throughout any report issuing
operation.
3. No Clerk Key is necessary to issue any of the reports.
4. Refer to the report samples on the following pages. As for the
PRESET VERIFICATION print samples, see the "VERIFICATION OF
PROGRAMMED DATA" near the end of this manual.
_ 00 _