Toshiba MA-136-100 SERIES - Manual (Page 41)

1. Set the Power Switch to OFF.
2.
Pull out the Store Message Stamp upwards. (Fig, 15)
3. Replenish ink to the bottom of the Stamp. (Fig. 16)
The amount of ink to be replenished should be 2 c.c. or less depending on the intensity of
print. (The supplied ink bottle contains 5 c.c. ink.)
WHEN A POWER FAILURE OCCURS
When power is restored, the register will display the last item entered before the power Failure
i f the item was entered through a notorized key (such as fDLPj], media keys, etc.). In this
case, contiue the registering operation. However, if the register displays "FAIL" when the power
is restored, it indicates that the last item entry was not completed (i.e., only numeric keys
or a declaration key such as LRlTl-ìlDiG were operated but not any motorized key). In this case,
first depress the [Q key to clear the "FAIL" condition, and then do the registering operation
again from the numeric or declaration key entry. In the event of a power failure, be sure to
check the receipt before it is handed to the customer,
SPECIFICATIONS
Size ............................... A60mn(width) x 400 fiìh )(depth) x 364mni(height) (SP MODELS)
Weight ............................. Approx. 18.5 kg (SP MODELS)
Power Required ..................... AC 117V
50/60 Hz (Varies depending on each area.)
Power Consumed ..................... 25 W
Size of Receipt and Journal Tape 38mm(width) X 70mm{diameter)
Ambient Temperature ................ o'"c ~ 40°C
10-90X RH
BEFORE CALLING FOR SERVICE
It is your dealer's primary concern to give full satisfaction and better service to our customers.
So if any problem arises in connection with the operation of this register, contact y o u r TEC
representative listed on the page. However, before calling for service, please check the follow­
ing points once again,
I In case the register is inoperative with a blank display and the printer will not turn.
. Is the register power switch turned on?
. Is the power cord of the register connected with the wall socket properly?
. Is AC power applied to the outlet? (Plug in a lamp or light fixture to check.)
. Has the fuse blown, or is the circuit breaker turned off?
In case the
outlet. receipt or journal is not feeding or the receipt is not coming out of the receipt
. Can the coloured lines on the receipt or journal paper be seen?
In this case, replace the receipt or journal paper with a new roll immediately.
. The receipt paper is jammed at the receipt cutter. In this case, remove the printer cower
and check the installation of the receipt paper.
YOUR TEC REPRESEHTATIVE; ____________________________________________________________________________________________
ADDRESS:
PHONE: