Toshiba MA-136-100 SERIES User Manual
Page 51
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
This page REVISED; April, 1983
S.F.K.C. (Selective Fiinction Key Code) SETTING (Condition: after a Z reset
&
a PLU reset)
This operation must be carried out first before any other programming
operations. If a RAM Clear operation has been done prior to this opera
tion, the S.F.K.C.'s of the Standard Keyboard should have automatically
been set; therefore, this operation may not be necessary and the MEMORY
OPEN operation will follow. However, in case any keys or positions are
to be programmed differently from the Standard Keyboard, this S.F.K.C.
operation must be done.
1. Turn the Power Switch to OFF.
2. Turn the RAM Clear Switch to ON.
3. Set the Clerk 2 Key to ON position.
(Please note that if none of the Clerk Keys are set to ON, a RAM Clear
operation will be performed.)
4. Turn the Mode Lock to SET position.
5. Turn the Power Switch to ON.
6. Enter each S.F.K.C. shown in the S.F.K.C. table and then depress the
key to require the function indicated with that S.F.K.C.
Repeat this step until all the required keys to be programmed or changed
with their own S.F.K.C.'s.
Please note:
(1) The key should be programmed first of all,
(2) To enable other programming and registering operation rightly,
the following keys must be programmed regardless of other
key selections:
0. S. IAT/TLI , [ST] , g] or [?7
n
^| , ITXI/MI (orjTxTMl ),:
and Department Keys.
7. When all the necessary S.F.K.C. *s are set, turn the RAM Clear Switch
to OFF.
NOTE: 1) If a wrong S.F.K.C. has been set on a key, do the operation in
Step 6 again with the correct S.F.K.C. and then depress the key.
The last S.F.K.C. entry into each key will be effective,
2) To cancel and close the use of a key, enter "0" instead of an
S.F.K.C. before depressing the key, in Step 6. The S.F.K.C. of
"0" locks the key and will not allow its use.
(In this case,
its memory will be closed also.)
3) To verify the S.F.K.C. already set, simply depress each of the
desired key without any number entry in Step 6 condition. The
S.F.K.C. is displayed but not printed.
- 6 B -