Replacing the journal paper roll, Replacing the ink roller, Replenishing ink to the store message stamp – Toshiba MA-136-100 SERIES User Manual
Page 40: Fig. 10 fig. 12, Fig. 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REPLACING THE JOURNAL PAPER ROLL
Fig. 10
Fig. 12
1. Open the Paper Cower.
2. Depress the IJFI key to advance the journal tape until unprinted part of the paper comes
out of the Journal Paper Guide,
3. Lift the printed journal together with the Journal Receiving Shaft and cot the journal paper
at the edge of the Journal Paper Guide, (fig. lO)
it. Remove the printed journal off the Journal Receiving Shaft.
5. Replace the existing journal paper roll with a new roll following the sane procedure as for
the receipt roll.
6, Depress the fjFI key to advance the Journal paper about 20 cm (8").
7, Insert the end of the journal paper into the slot on the Journal Receiving Shaft and wrap
it around the shaft twice to secure the paper. {Fig, U)
8. Place the Journal Receiving Shaft into the guide slots so that the shaft gear engages with
the journal take-up motor gear.
REPLACING THE INK ROLLER
Ink Roller
Ink Roller Case
Fig. 14
1. Set the Power Switch to OFF.
2. Remove the stamp cover to gain access to the Ink Roller and Stamp Assembly, (fig, 13)
3. Pull the Ink Roller Case upwards with your right fingertips, (fig. H)
A. When replacing the Ink Roller, use a vinyl glove or cover the Ink Roller using the vinyl
strip to prevent inking the hands.
REPLENISHING INK TO THE STORE MESSAGE STAMP
Stamp Case