Specifications – Kenwood COMPACT DISC DIGITAL AUDIO UD-703 User Manual
Page 78
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Specifications
(For U.S.A. and Canada}
Tuner/Amplifier unit (C-F7/A-F7)
________
FM Tuner section
Tuning frequency range..........................87.5 MHz ~ 108 MHz
Sensitivity (IHF)................................ 13.2 dBf (1.2 |iV at 75 Q)
Signal to noise ratio at 1 kHz
MONO.................................................75 dB (65 dBf input)
STEREO..............................................68 dB (65 dBf input)
Selectivity (IHF ± 400 kHz).................................................50 dB
Stereo separation (IHF at 1 kHz).......................................40 dB
Frequency response............. 30 Hz ~ 15 kHz + 0.5 dB, - 3 dB
AM Tuner section
Tuning frequency range.......................... 530 kHz ~ 1,700 kHz
Usable sensitivity........................... .........12 piV / (500
|
li
V
/ m)
Signal to noise ratio......... ................................................. 48 dB
[General]
Dimensions......................................... W : 270 mm (10-5 / 8")
H : 104 mm (4-1/8")
D : 334 mm (13-1/8")
Weight (net)................... .............. ........................ 2.0 kg (4.4 lb)
UD-703/753 [En)
Amplifier section
Rated power output
80 watts per channel minimum RMS, both channels
driven, at 8 from 40 Hz to 18 kHz with no more than
0.4 % total harmonic distortion.
SURROUND MOPE
CENTER (1 kHz, 1 % T.H.D. at 8 П)............................ 10 W
REAR (1 kHz, 1 % T.H.D. at 8 П) .............. .........3 W + 3 W
Signal to noise ratio
VIDEO 1,2................ ....................................87 dB (IHF'66)
Input sensitivity / Impedance
VIDEO 1,2 ............................................. . 200 mV / 33 kQ
MIC............................................... ...............2.0 mV / 22 kQ
Output level / Impedance
SUPER WOOFER PRE OUT..........................2.0 V / 600 О
TAPE REC.................. ............................... 200 mV / 47 kQ
Video section
Input level / impedance
VIDEO (composite)....................................... 1 Vp-p / 75 Q
Input (VIDEO 1, VIDEO 2 / AUX)
Output level / Impedance
VIDEO (composite)....................................... 1 Vp-p / 75 Q
Output (MONITOR, VIDEO 1)
[General]
Power consumption......................................................... 150W
Dimensions......................................... W: 270 mm (10-5 / 8")
H : 124 mm (4-7 / 8")
D : 336 mm (13-1 / 4")
Weight (net)........................................................ 6.1 kg (13.41b)
I
[yjQjg
I KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without
notice.
For the U.S.A.
FCC WARNIIMG
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are "expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an
unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause
harmful interference to radio communications, if it is not installed and used in accordance with the instructions. Flowever, there is no guaran
tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- - Reorient or relocate the receiving antenna.
- - Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—
Consult the dealer or an experienced radio / TV technician for help.